• Foster serie 3, 4, 5, y 6
• Parker serie-20 intercambio manual (Serie F)
• Hansen 1000, 400, 500

• Los componentes son maquinados con barras sólidas de acero, latón o acero inoxidable 303
• Los balines de acero inoxidable, anillos de retención y resortes maximizan la resistencia a la corrosión y extienden la vida de ser vicio
• Sellos de nitrilo (Buna-N) estándar
• Los componentes de acero son platinados con cromo trivalente y cumplen con la norma ROHS
• Manga y válvula tubular de acero

• To disconnect, begin by holding the hose on the nipple side with three of your fingers, leaving your thumb and index finger free.
• Grab the sleeve with your thumb and index finger and begin to pull the sleeve towards the palm of your hand.
• After pulling the sleeve, the nipple will move out of the coupler slightly. Continue to hold the hose and coupler sleeve until all air is fully exhausted.
• After the line is fully exhausted, you are able to safely separate the nipple from the coupler.

It is important to be safe when installing quick disconnect couplings into a pneumatic circuit. Never install a pneumatic coupling directly into an air tool, use a piece of hose that is at least 18" long, between the tool and the coupling, to prevent damage to the coupling. To protect the operator, safety devices, such as a safety check valve and safety cable should be installed in case there is a hose or coupling failure.

Valuación de presión de cople y niple de acero: Trabajo máximo 500 PSI (35 bar) y Reventón 19,500 PSI (1,345 bar)